A poultry chicken wire fence is a hexagonal pattern fence that is traditionally used to keep chickens in a chicken house. However, it is considered to be a very flexible building material with a variety of installation options and is used for many other purposes. All they require are fence posts or frames to provide support and hold the fence in place.

Chicken wire is usually used to control livestock in the open air and prevent predators. Installation requires basic tools and the ability to perform manual work. Here are a few steps that can help you install your poultry chicken wire fence with ease.

  1. Set up your fence posts or construct a frame before installing wires. Place fence posts no more than 10 feet away. Longer distances reduce the ability to maintain proper tension.
  2. Staples can be easily installed using wooden fence posts or frames. Metal T-pillars is an option, but they offer limited height options and difficult connections.
  3. These frameworks are ideal for raising chickens and cattle in areas where there is a risk of predators. The box frame allows cables on all sides to enclose the animal.
  4. Dig a trench of at least 1 foot deep for the wires along the fence to avoid dogs and wild animals digging under the fence to chase livestock.
  5. Pour a layer of concrete into the trench to increase the safety of excavation. Do not pour concrete until the fence is installed and functional.
  6. Determine the required height before installing the cable. The wood frame may need to be customized in height to suit your design.
  7. Use pliers to measure and cut to fit your frame. The fenced area uses a height of 6 feet. The shredded chicken has a 6-foot roll. Planting the wire will lower the height, but few chickens will fly over a 5-foot fence. When designing the chicken house, plan an area of ​​approximately 4 square feet for each bird.
  8. The correct installation is the work of two people. The chicken wire is too soft for the windshield wiper, and hand-pull is the best installation method. Align one edge of the wire with the edge of the first fence post or frame.
  9. Hammer poultry staple food into the top, center, and bottom of the fence. Use a nail gun to fix the area between the poultry nails.
  10. Let your partner’s hand pull the wire to the next part while fixing the fence in the same way.
  11. Use wire cutters to cut off the excess wires after finishing.

Building a Poultry chicken wire fence is usually considered easy when looking at it. However, it needs precision, finesse, and planning while building it. Moreover, the quality of the wire also matters. So take a look at Tata Wiron Poultry chicken wire.

Leave a Reply